This is the ON-OFF switch. To Start programing turn
the ON-OFF Switch to ON position.
PROGRAMMING KEYS
1) MODE
2) UP ARROW
3) DOWN ARROW
4) LEFT ARROW
For programming, take your switch to the ON
position. Press MODE key for 2 seconds, you’ll see
Su displaying on the screen. Once the Su appears
on the screen Press the “Left” arrow button once;
you will see that a digit of the green number at the
lower line of your DC will start blinking.
1) 2) 3) 4)
Temperature inside the Firing Chamber in ℃
Target Temperature in ℃
You can leave it as it is or change it by pressing UP
and DOWN arrow keys. For changing the other digits
value, you can move the blinking digit by simply
pressing the LEFT arrow and adjust is as explained
before.
1
This is the digital controller of you kiln. It shows you
the inner temperature of your kiln and the target
temperate when your kiln is in the ON Position.
To Next Page
Loading...
Need help?
General