To Next PageTo Next PageWhat to do if external fault in ProMinent Water System?
If there's an external fault, it means the contact input for an external fault has been activated. Check connected systems for the external fault and eliminate it.
What to do if overheating - lamp is cooling in ProMinent Water System?
If overheating occurs and the lamp is cooling, it's likely due to the water temperature in the radiation chamber being too high, which has caused the system to switch off. Ensure adequate water flow to resolve this.
What to do if Water temperature exceeding 65 °C in ProMinent Water System?
If the water temperature exceeds 65 °C, it's likely due to overheating in the radiation chamber caused by stagnation or low water flow. Ensure adequate water flow to resolve this issue.
What to do if wiper is not calibrated on ProMinent Water System?
If the wiper is not calibrated, you should calibrate it.
What to do if temperature of control cabinet above 45 °C in ProMinent ProMaqua Dulcodes A Water System?
If the control cabinet's temperature exceeds 45°C, it may be due to inadequate cooling caused by a used filter mat, a defective fan, high ambient temperature, or obstructed air inlet/outlet. Eliminate the source of the error and monitor the result.
What to do if low UV intensity after wiper cycle in ProMinent ProMaqua Dulcodes A Water System?
If the UV intensity remains low after a wiper cycle, it could be due to an aged UV lamp with low UVC power, poor water transmission, stubborn dirt on the radiator protection tube not fully removed by the wiping cycle, or a dirty or faulty UV sensor. Consider these steps: * Replace the UV lamp. * Check the water transmission and improve pre-treatment if necessary, or adjust system settings to water quality. * Manually clean the lamp protection tube. * Clean the UV sensor, and replace it if necessary.
What to do if UV intensity is below warning threshold in ProMinent Water System?
If the UV intensity is below the warning threshold, it might be because the UV lamp has aged and the UVC power is too low, the water transmission is poor, or there's dirt on the lamp protection tube or UV sensor, or the UV sensor is faulty. You should: * Replace the UV lamp. * Check the water transmission and improve pre-treatment if necessary, or adjust system settings to water quality. * Manually clean the lamp protection tube. * Clean the UV sensor and replace it if needed.
General| Manufacturer | ProMinent |
|---|---|
| UV lamp type | Not applicable |
| Product Line | ProMaqua |
| Application | Swimming pools |
| Disinfection Method | Electrolysis |
| Power Supply | 230 V, 50/60 Hz |
| Operating Pressure | Max. 3 bar |
| Operating Temperature | 5 - 40 °C |
| Control | Microprocessor-based control |
| Communication Interface | Modbus |
| Weight | Dependent on model |
| Certifications | CE |
| Material | Titanium |
| Monitoring | Redox |
