EasyManua.ls Logo

ProMinent ProMix S - User Manual

ProMinent ProMix S
59 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ProMinent ProMix ‘S & C’ Polymer Feeder
ProMix Series S&C User Manual
Operating Instructions
ProMinent
®
ProMix-S & C
Polymer Blending Systems
Please completely read through these operating instructions first! Do not discard!
The warranty shall be invalidated by damage caused by operating errors!
ProMix_S&C_IOM (02/26/2020): – P/N: 984704-(Rev-E)
ProMinent Fluid Controls, Inc. (USA) 136 Industry Drive, Pittsburgh, PA 15275
Tel: (412) 787-2484 www.prominent.us Fax: (412) 787-0704

Table of Contents

Questions and Answers

  • T
    Timothy ReyesAug 9, 2025
    What to do if my ProMinent ProMix S shows 'No Water STOP'?
    • W
      William AdamsAug 9, 2025
      If your ProMinent Mixer displays a 'No Water STOP' error, there are several potential causes. First, if it's a flowswitch or differential pressure switch issue, temporarily bypass the controller by connecting the Interlock input terminal ‘FS’ to the adjacent Ground symbol terminal while you troubleshoot. Second, check if the solenoid is activating during the Filling Mixer and Flow Check states by loosening a downstream union. Finally, if there's no AC solenoid power, check the solenoid wiring and coil for shorts, and replace the solenoid fuse (the brown 2.5A fuse in the white socket above the Neutrals terminals; www.digikey.com Part# 7500413). Note that the mixer motor start relay coil shares this fuse.
  • A
    Amanda SummersAug 26, 2025
    How to fix 'No Control STOP' on a ProMinent Mixer?
    • D
      Don SmithAug 26, 2025
      If your ProMinent Mixer displays a 'No Control STOP' message, switch the On-Off-Remote to On while you troubleshoot the 4-20mA current loop connected to mA In input terminals ‘I+’ & Ground terminal. If the ProMix S mA In 24V is powering the loop, check Polymer / Diagnostic to ensure it reads >23VDC.

ProMinent ProMix S Specifications

General IconGeneral
Operating temperature-20 °C to +120 °C (depending on the material)
MaterialsPP, PVDF
Operating pressure10 bar
ViscosityUp to 1000 mPa·s
Power SupplyN/A (static mixer)