Power amplifier TL series
2022-11-21 Pronomic TL Serie / ArtNr.: 00063864/00021732/00021733/00021734 7
PARALL-MODE (MONO) - In this mode, both channels can be operated in parallel
with the same signal without the need for a Y-cable.
In this mode, the inputs for both channels are internally connected, so you only need
to feed one signal into one of the channels. This further allows independent level
control for each channel. It also allows for easy "Daisy-Chaining" with other power
amplifiers by using the other channel of the input terminals.
Do not select parallel mode if you supply the power amplifier with 2
separate signals.
Do not use unbalanced and balanced cables at the same time,
otherwise hum may occur.
STEREO-MODE - This is the most commonly used mode and allows independent
control of two separate signals, such as stereo playback, main and monitor live mix,
and bi-amp operation (highs in one channel and lows in the other).
BRIDGED-MODE (MONO) - This mode combines the power of both channels to
drive a single speaker. In this mode, the power amplifier generates 4 times peak
power and 3 times continuous power in a 4 or 8 ohm speaker, as each channel can
deliver separately in stereo or parallel mode.
In this mode, the power amplifier can power a loudspeaker
with high power. Make sure the speaker, connectors, and
cabling is adequate for performance. Please note that with a 4-
ohm loudspeaker, the mains fuse can blow during prolonged
overload. Check that the power amplifier is not overloaded
when setting this mode.
Connect the input signal to the CH-1 input to bypass the mono
operation.
To Next Page
Loading...