Propex HS2000 - Overview of Digital Thermostat; Heater Compatibility; Package Contents; Thermostat Fault Finding

Page
1
OVERVIEW
Thank you for purchasing this digital thermostat, designed to complement and
enhance the operation of your Propex or Whale space heater.
This thermostat is designed to control the operation of your blown air heater whilst
maintaining the desired cabin temperature. Air temperature is measured at the
thermostat and when the ambient air temperature meets the set temperature will
switch the heating function off. Should the ambient air temperature drop by approx. 2
degrees, as measured at the digital thermostat, so the heating function will be
restarted. The thermostat will maintain this cycle until switched off.
For models for use with Gas only heaters a countdown timer function is available.
COMPATIBILITY
Program 1 (Gas only Heaters) Program 2 (Gas or Electric Heaters)
HS2000 HS2000e
HS2800 HS2202
HS2211 HS2212
WHATS INCLUDED
Panel mounted Digistat, removable bezel, mounting template, instructions.
The digistat is designed to accept the decorative bezel manufactured by CBE in Italy,
this is widely available in a variety of colours and finishes.
Page
6
For heaters manufactured from 2016 and prior to April 2018 – ensure the set
temperature is above ambient. Press the gas control button ON – then
switch it OFF – then switch back ON. Within 2.5 seconds.
For heaters manufactured from April 2018 – Switch the unit off. In the bottom
right hand corner near the display is a small hole containing a concealed
button. Using a paper clip or similar, carefully insert into the hole and gently
press the button twice leaving 1 second between each press.
Scan the QR code for the You tube 2018 reset video
FAULT FINDING
Fault
Reason
Solution
No response from
thermostat
Heater is not powered
up
Check heater has
power
Not responding to key
Presses
Keys being pressed to
o
quickly
Use a more positive key
action
Thermostat does not
immediately bring on
green led.
Built in delay
W
ait
2 seconds after
desired temperature
position is reached
Cannot reset fault on
heater
Wrong reset sequence
for heater being used
Check manual for
heater.
Cannot reset fault on
heater
Reset sequence being
carried out too fast
Allow 1 second
between ON activation
For further assistance please contact your supplying dealer.