1. SUBWOOFER LEVEL
Adjust this knob for independent control over the subwoofer.
2. SATELLITE LEVEL
Adjust this knob for independent control over the satellite speakers.
3. INPUTS
Use these combi-jack inputs to connect line-level sources such as mixing consoles.
4. LINE OUT
Use these XLR outputs to send your signal to another subwoofer or system.
5. VOLTAGE SWITCH (115V/220V)
When powering on please ensure that the indicated voltage matches your supply. Please note that the
wrong voltage can cause serious damage to your unit.
6. SPEAKER SOCKETS (NL4)
Use these sockets to connect your subwoofer with the satellite speakers.
7. DSP INDICATOR
These LEDs indicate which DSP preset is engaged.
8. DSP PRESET
The DSP knob allows you to choose from one of four presets.
• STANDARD
• DJ 1
• DJ 2
• LIVE
9. BLUETOOTH SWITCH
Press the Bluetooth switch. If the connection is successful, the blue light will stay on. If the connection fails,
the blue light will keep flashing.
If you want to use the TWS mode, then press and hold the Bluetooth switch for three seconds until the red
light turns on. If the red light is blinking, the connection is not successful. If the red light is on, the connec-
tion is successful.
10. STEREO / MONO BUTTON
This button allows you to alternate between stereo and mono playback to suit the needs of your perfor-
mance and environment. When engaged the signal is summed to mono. When disengaged the signal is
heard in stereo.
11. POWER SWITCH
Use this switch to turn the unit on and off.
12. MAIN POWER INPUT
Use the supplied mains cable to provide power to the unit via a mains socket. Please note only use the
same type of fuse that comes installed from the factory (T5AL 250V).
FUNCTIONS -SUBWOOFER
11
To Next Page
Loading...