EasyManua.ls Logo

PRORUN PRM48V38 - Page 45

PRORUN PRM48V38
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
45
6. The best height of the grass on a well-kept lawn is approximately 2.5 – 3.0 inches
(6-7 cm). With one cut, you do not need to remove more than a third of the total
height. If the grass is very tall, it should be cut twice in a twenty-four-hour period.
The first time with the blades at maximum height, possibly reducing the cutting
width, and the second cut at the desired height.
7. When you mow large areas, start by turning to the right so that the cut grass will
discharge away from shrubs, fences, driveways, etc. After one or two rounds,
mow in the opposite direction making left turns until finished.
8. The appearance of the lawn will improve if you alternate cutting in both
directions.
9. If the collector system tends to get blocked with grass; you should reduce the
forward speed as it may be too high for the condition of the grass. If the problem
persists, the probable causes are either badly sharpened blades or deformed
wings.
10. Be very careful when mowing near bushes or curbs as these could distort the
horizontal position of the cutting deck and damage its edge as well as the
blades.
TRANSPORT
To change work areas, the machine can only cover short distances.
For longer distances, use a transport vehicle featuring loading ramps.
Push the machine by hand.
Do not lift using cables.
Secure the machine adequately during transport.

Other manuals for PRORUN PRM48V38