CARE AND MAINTENANCE
No audio
-Make sure the MUTE indicator on the front panel
is off.
-Make sure the speakers are turned on.
-Check the connections.
-Check the short plug between PRE OUT jacks
and AMP IN on the rear panel is inserted.
-Check the power cord connection.
No audio from one channel.
-Check the speaker wire connection or connecting
cable.
-Noise when the TV is turned on, the TV too close
to the audio system.
-Check the connection between the receiver and
the speaker.
The sound does not match the video.
-Press the function button for the video source.
TROUBLESHOOTING TIPS
RECEIVER/TUNER OPERATION
STEREO indicator is off.
-Adjust the antenna.
-The signal is too weak. Connect an external
antenna.
-The signal is Mono.
-Sever hum or noise.
-The signal is too weak. Connect an external
antenna.
REMOTE CONTROL OPERATION
The remote control does not operate the unit.
-Another function is selected on the remote.
Press the correct function button.
-No batteries installed. Install the batteries before
attempting to operate the remote.
Be sure to match the + and ends of each battery
to the symbols shown in the remote battery
compartment.
-The batteries are exhausted. Replace all batteries.
-The remote is not pointed at the remote control
sensor on the main unit or there is an obstacle
between the remote and the main unit.
-The remote control is too far from the main unit
-Move closer.
GENERAL
-Disconnect the system from AC power before
cleaning the exterior of the system with a soft
dust cloth.
CLEANING THE EXTERIOR
13
To Next Page
Loading...