7. CYCLE 1 - BACKWASH
The control will display:
8. CYCLE 2 - BRINE/SLOW RINSE
The control will display:
Press the Up or Down ARROW to change the length of the brine/slow rinse cycle. The minimum length
is preselected based on unit size and salt level, and cannot be reduced. The maximum setting is 99
minutes.
Press the SCROLL BUTTON to advance to the next setting.
9. SERVICE PHONE NUMBER
The control will display:
If you do not want to change the phone number, leave this setting at NO. Press SCROLL to advance
to EXIT.
To change the number, select YES; Press the UP or DOWN ARROW and then enter the service phone
number. Press Scroll to advance through the digits. After setting the number, press SCROLL to exit the
installer’s level; the screen will display:
Press the UP or DOWN ARROW to exit the Installer’s Level.
Note: If you need to recheck settings or make a change, pressing SCROLL when “EXIT” is
displayed will take you back to the start of Installer Settings.
IMPORTANT NOTE: TO ACTIVATE THE NEW SETTINGS, YOU MUST EXECUTE A COMPLETE
REGENERATION. IF YOU DO NOT MANUALLY REGENERATE THE SYSTEM, THE SETTINGS WILL
NOT BECOME ACTIVE UNTIL THE UNIT HAS COMPLETED THE NEXT SCHEDULED REGENERA-
TION.
11
BRN/RNS: 60 min
Backwash: 10 min
Change Phone? No
000-000-0000
Exit
To Next Page
Loading...