N 93-310-00 Issue 0 Page 4 of 4 © Protec Fire Detection PLC 2012
6.0 RESETTING FIRE EVENTS
After ‘silencing alarms’ (Section 2.4) and establishing the cause of the fire :-
a) Press the ‘RESET’ button.
Any fire indications will be extinguished.
Any plant equipment (control outputs) will be reset.
The fire condition will re-start if an automatic detector or manual call point remains active.
7.0 DISPLAY OF FAULT EVENTS
In the event of a fault appearing on the system the panel buzzer will sound intermittently, and the ‘FAULT’
LED will illuminate. The LCD will also display the number of faults to view.
For the full version of this operating manual is available from www.protec.co.uk
To Previous Page
Loading...
