Protec Algo-Tec 6500 - Document Revision Details

RDM0002/3 Page 2 of 57 © 2015 - 2019 Protec Fire Detection plc
Document Revision Details
Issue
Modification Detail
Author
Date
2.8
Updated DLP Card addresses
Updated loop Initialisation Fault
Updated device type fault
Added Device Zone Trans Fault
PD
12/12/2018
2.9
Added description of the Promoted master
Updated the description of the MIMIC Device
Missing fault
Added description of Deluge Drive Limit Fault
Updated the description of the Unknown
Active Device Fault
Added damper control module faults
PD
02/05/2019
2.10
Added description of the Loop Disablement
CRC Fault.
Added description of the Loop DLP Queue
fault.
Updated licence fault descriptions.
Added description of the WODU Interface
Board Missing fault.
Updated the description of the Unknown
Active Device Fault.
Renamed Circuit Fault as Supply Out Fault
and updated the description.
Renamed Set Point Position fault as Position
Fault and updated the description.
PD
01/07/2019
3
Minor changes
PD
19/07/2019
Notice
This manual may be revised as a result of enhancements to the system software or hardware. Check
for revisions to this manual, and download them, from the website www.protec.co.uk