protech YADA ST - Basic Setup Sheet; Track Conditions and Suspension Setup; Shocks, Differentials, and Clutch Setup; Engine, Tyres, and Race Results

Track Conditions:
Size: Open Med. Tight
Traction: High Med. Low
Surface: Smooth Med. Bumpy
Name : ___________________
Track :
Date : ___________________
Weather : ___________________
Front Shocks:
Piston: 2 holes
Oil: 500
Spring: Blue
Spacer: 2mm
Shock Position:
Front Suspension: Track Width: 295mm
Camber Angle: -2°
Upper Arm Spacer: 4mm
Toe Angle: -1°
Rebound Stop: 2mm
Anti-roll Bar: Use 2.3mm
None
Lower Arm mount (kick up):
1°
Upper Arm position: PL0042-0A
Lower Arm spacer: 2mm
Rear Shocks:
Piston: 2 holes
Oil: 450
Spring: Blue
Spacer: 5mm
Shock Position:
Steering Ackerman:
Wing Position:Differential oils:
Front: #7000 O-Ring 0 pcs.
Center: #7000 O-Ring 0 pcs.
Rear: #10000 O-Ring 0 pcs.
Clutch: Shoes: Aluminium
Other:original ST
Spring: 1.0 mm
Clutch Bell / Spur Gear : 13T / 44T
Comments:
Drive shafts rear & front “level”___
6V Receiver battery pack used
______________________________
______________________________
______________________________
Protech SX-21 8P Omega used__________________________
for test, with Rossi glowplug #7_____________________________
______________________________
Upper Arm Spacer
Track Width
Rebound Stop
Rear Suspension:
Camber Angle:-1.5°
Lower Arm mount: (Toe Angle)
2°
Rebound Stop: 3mm
Anti-roll Bar: Use 2.9mm
Upper Arm Position None
Anti-Squat :
Wheelbase Adjustment
Low-Right Pin Position
5.2mm
Front
Upper Arm Position
Tyres: YADA ST original tyres
Front: Rear:
Tyre: Original Pin Tyre: Original Pin
Rim: Original Rim: Original
Insert: Original Insert: Original
Rim
Rim
Race result:
Race Time / Laps :
TEST
Position in Race:
TEST
Fuel Nitro % oil %
DAYTONA 25%
_____________
_____________

Best lap:
3527(&+5$&,1*7($0
2))52$'1,752EXJJ\
295mm
30mm
20mm
___________________
Engine:
TEST
Basic Setup Sheet