Important InformatIon for users 5
Operation
The fog cannon is primed whenever the alarm system is activated. If
you then enter the secured area, both alarm and fog cannon will be
triggered.
When you disconnect the alarm, the fog cannon will be disconnected
automatically.
Depending on the installation
method and the fog cannon
model, it may take up to 45
minutes for the unit to become
warm enough to generate fog. We
recommend that you keep your
fog cannon products warmed up
at all times so they are ready to
generate fog as soon as the alarm
system is activated.
Every fog cannon is monitored by the alarm company from which it was
purchased (or the relevant subcontractor). The alarm company can
register activation of the fog cannon, attempted vandalism and errors.
An authorised alarm tter must be engaged to set the fogging time,
etc. and to replace the fog uid container (however, end users them-
selves can replace the uid container in PROTECT QUMULUS models
manufactured after 1 September 2014). The same as for model Xtratus.
Scan the codes with a smartphone to
check how to replace the fl uid container
in a QUMULUS model manufactured
after 1 September 2014 or a Xtratus.
PROTECT Xtratus = 8 min.
PROTECT FOQUS = 7 min.
PROTECT QUMULUS = 8-10 min.
PROTECT 600i = 10-15 min.
PROTECT 1100i = 20-25 min.*
PROTECT 2200i = 35-40 min.*
*We recommend that you keep
the power connected 24/7.
QUMULUS Xtratus
To Next Page
Loading...
