True-RMS Multimeter
2
Warning. Read before use
To avoid possible electrical shock or personal injury, follow these instructions and guidelines.
▶ Make sure that the Meter should be used only as specied in this manual
▶ Stop using the Meter or test leads if they look damaged, or if the Meter is not operating
properly
▶ Make sure that only the rated voltage should be applied to the Meter, as marked on meter
▶ Replace the battery immediately as soon as the low battery indicator( ) is displayed
▶ Disconnect the test lead from test point before changing the meter function and range
▶ Do not measure voltage out of specication(over 1,000V)
▶ Verify the meter’s operation by measuring a known voltage
▶ Use caution with voltages above 20V ac rms, 42 V ac peak, or 60 V dc.
▶ Disconnect circuit power and discharge all high voltage capacitors before testing resistance,
continuity, diodes, or capacitance.
▶ Remove the test leads before opening the case or battery cover.
▶ The Meter is for indoor use only(IPX0)
▶ Use the Meter with test probe(Model # GTP01)provided by GSI.
▶ The protection provided by the Meter may be impaired if the Meter is used ina manner not
specied by the manufacturer.
To Next Page
Loading...