Why does my Prowinch PWHF1000i Chain Hoists operate in a non-load state?
Your Prowinch Chain Hoists might be operating in a non-load state due to a default phase (single phase operation), issues with the feed power, motor problems, or a contactor junction fusing. Check the power, feed power, motor, and contactor.
Why does my Prowinch Chain Hoists not operate in a non-load state?
If your Prowinch Chain Hoists isn't operating in a non-load state, it could be due to excessive voltage, an operating circuit break-off, overheating electric parts, internal wiring issues, contactor problems, a faulty transformer, or a problem with the up/down limit or button switch. Check the power, power supply, internal wiring, contactor, transformer, up/down limit switch and button switch.
Why is my Prowinch PWHF1000i lifting slowly?
If your Prowinch Chain Hoists is lifting slowly, it might be due to low voltage. Check the feed power.
General| Model | PWHF1000i |
|---|---|
| Load Capacity | 1000 kg |
| Lifting Capacity | 1000 kg |
| Power Supply | Electric |
| Voltage | 110V |
| Motor | 0.75 kW |
| Power | 0.75 kW |
| Phase | Single |
| Chain | G80 |
| Chain Fall | 1 |
| Frequency | 60 Hz |
| Lift Height | 3 m |
| Lifting Height | 3 m |
To Next Page
