Why my Prowinch Chain Hoist does not operate?
If your Prowinch Chain Hoist isn't operating, it could be due to excessive voltage or overheating electrical parts causing the circuit to break. Check the power supply. Other potential issues could be with the internal wiring, contactor, transformer, up/down limit switch, or the button switch.
Why my Prowinch Chain Hoist operates without load only?
If your Prowinch Chain Hoist operates without a load, it could be due to a default phase (single phase operation). Check the power feed. Other potential issues could be with the motor or contactor (junction fusing).
How to stop non-stop activation of Prowinch PWA Chain Hoists?
If your Prowinch Chain Hoist is experiencing non-stop activation, it could be due to junction welding burn out. If continuous welding or burn out occurs, change the contactor. For electric reply, perform a visual inspection of the junction. Avoid over-operation. Excessive voltage (excessive current) can also cause this, so operate under rated voltage.
General| Brand | Prowinch |
|---|---|
| Model | PWA |
| Category | Chain Hoists |
| Language | English |
General safety advice and warnings for using the hoist.
Specific safety rules and warnings related to hoist operation.
Pre-operation checks and requirements before using the hoist.
Guidelines and warnings for safe hoist operation.
Procedures for inspecting, maintaining, and repairing the hoist.
Safety guidelines for grounded and double insulated electrical units.
Step-by-step procedures and best practices for operating the hoist.
Common problems during operation and their causes/corrections.
To Next Page
