Prowinch PWA - Pairing Transmitter and Receiver

Version 1.0
35
Inspection & Maintenance
35
Pairing transmitter and receiver
Follow these instructions to pair the transmitter:
1. Disconnect the power supply from the receiver.
2. Remove the battery from the transmitter.
3. Return the battery to the transmitter, then hold down the “up” and “start” buttons until the Red LED on the transmitter ashes
rapidly.
4. Re-connect the receiver to the power supply. The red LED on the transmitter will begin to ash slower. At this point, the trans-
mitter and receiver are paired.
If you need to change the code and channel on the transmitter, complete one of the following:
TO COPY TRANSMITTER CODE AND CHANNEL TO THE RECEIVER
Press “UP” key to complete this operation.
TO COPY RECEIVER CODE AND CHANNEL TO THE TRANSMITTER
Press “DOWN” key to complete this operation.
If the process has been successful, the green LED on the transmitter will ash once.
STOP
START
UP
DOWN
SAFETY
KEY
STOP
START
STOP
START
UP
DOWN
LEFT
RIGHT
SAFETY
KEY
STOP
START