ORiNOCO
®
802.11n Access Points - Software Management Guide 57
Figure 5-20 AP - Edit Wireless Security Profile
Configure the following parameters:
Click OK and COMMIT, to save the configured parameters.
5.5.2 RADIUS
Remote Authentication Dial In User Service (RADIUS) is a networking protocol that provides centralized Authentication,
Authorization, and Accounting (AAA) management for nodes to connect and use a network service.
The AP device supports the following authentication and accounting mechanisms:
• MAC Access Control Via RADIUS Authentication: Allows only the MAC addresses that are registered on the
RADIUS server to access the wireless network.
• 802.1x Authentication using RADIUS: Refer 802.1x Authentication
• RADIUS Accounting: By using an external RADIUS server, the AP device can track and record the length of the client
sessions by sending the RADIUS accounting messages per RFC2866. When a wireless client is successfully
authenticated, RADIUS accounting is initiated by sending an “Accounting Start” request to the RADIUS server. When
the wireless client session ends, an “Accounting Stop” request is sent to the RADIUS server.
: For the AP device to support the above authentication and accounting mechanisms, ensure to configure the RADIUS
server. For more details on configuring a RADIUS server, please refer to ‘AP11n - Reference Guide’.
5.5.2.1 Authentication Attributes
• User-Name: Specifies the name of the user that needs to be authenticated. It must be sent in Access-Request packets,
if available.
• User-Password: Specifies the user password to be authenticated, or the user's input following an Access-Challenge.
It is only used in Access-Request packets.
Parameter Description
Profile Name Specifies the name of the Security Profile that is being created. To configure, enter the
desired Profile Name.
Authentication
Mode
Specifies the security mode for the wireless network. The Auth Mode may vary between
None, WEP, PSK, 802.1x. (See Create a New Security Profile)
Entry Status Specifies the status of the security profile selected.
By default, it is enabled. To configure, select the Entry Status from the drop down menu.
To Next Page
Loading...
Need help?
General
