Need help?Do you have a question about the Proxxon 24 264 and is the answer not in the manual?
Mount the dividing attachment horizontally or vertically; long work pieces can pass through the baseplate.
Tighten the knurled screw to clamp the work piece using inner or outer jaws, turning clockwise or anticlockwise.
Remove, turn, and re-insert jaws by turning the stop screw, ensuring number correspondence for correct fit.
Position the chuck to one-degree increments by aligning marks on the degree scale and vernier scale through the housing.
Contact PROXXON GmbH for device malfunctions, parts orders, and prompt, reliable service.
Include fault description and proof of purchase for warranty returns. Ship in original packaging to prevent transport damage.
To Next Page
General
