This safety and general information document contains safety and
information symbols that are relevant while using the system. The
document contains detailed laser safety information. The following
handling aspects are also dealt with: storage, care, maintenance,
disposal and transport. Safety specifications, FCC requirements,
notes on data storage, general information, and system warranty
form part of this document.
Contents subject to change without further notice, particularly in
the interest of further technical development.
Safety and general information
Symbols
The CAUTION symbol denotes information which
must be followed in order to avoid damage to
equipment.
The WARNING symbol denotes information which
must be followed in order to avoid personal injury.
The laser safety warning symbol denotes laser
radiation.
The Note symbol denotes general information and
tips regarding use of ROTALIGN touch.
The Electrical hazard symbol is used to identify
electrical hazard and high voltage areas.
Denotes conformity to relevant Australian standards.
Denotes conformity to requirements of European
Union and European Free Trade Association.
Denotes conformity to relevant South Korean EMC
standards.
Denotes that any waste electrical and electronics
parts of the ROTALIGN touch system including
memory sticks must be disposed of according to
applicable safety and environmental regulations.
Denotes that the product is made of parts that are
recyclable.
Laser safety
The system uses a Class 2 laser according to the requirements of
IEC 60825-1:2007. This laser complies with 21 CFR 1040.10 and
1040.11 except for deviations pursuant to Laser Notice No. 50,
dated June 24, 2007. The laser operates at a wavelength of 635
nm and has a maximum radiant power <1 mW. No maintenance is
necessary to keep the product compliant as outlined above.
To Next Page
Loading...
Need help?
General
