en
Notes regarding data storage
As with any data processing software, data may be lost or
altered under certain circumstances. PRÜFTECHNIK strongly
recommends that you keep a backup or printed record of all
important data.
PRÜFTECHNIK assumes no liability for data lost or altered as a
result of improper use, repairs, defects, battery replacement/
failures or any other cause.
PRÜFTECHNIK assumes no responsibility, directly or indirectly,
for financial losses or claims from third parties resulting from
the use of this product and any of its functions, such as loss
or alteration of stored data.
Safety specifications
Power supply
ROTALIGN touch computer Lithium-Ion rechargeable battery:
3.6 V / 80 Wh
sensALIGN sensor Lithium Polymer rechargeable battery:
3.7 V / 1.6 Ah 6 Wh
sensALIGN laser Lithium Polymer rechargeable battery:
3.7 V / 1.6 Ah 6 Wh
Temperature range
ROTALIGN touch
computer
sensALIGN sensor sensALIGN laser
Operating 0°C to 40°C
[32°F to 104°F]
-10°C to 50°C
[14°F to 122°F]
-10°C to 50°C
[14°F to 122°F]
Storage -10°C to 50°C
[14°F to 122°F]
-20°C to 60°C
[-4°F to 140°F]
-20°C to 60°C
[-4°F to 140°F]
Charging 0°C to 40°C
[32°F to 104°F]
0°C to 40°C
[32°F to 104°F]
0°C to 40°C
[32°F to 104°F]
Camera LEDs (eye safety)
The system camera LEDs are considered Risk Group 1 according to
IEC 62471:2006. DO NOT look directly at the operating LEDs, as
eye injury may result.
FCC requirements
A) User information according to FCC15.21
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
B) Statement for Class B digital device according to FCC 15.105
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
To Next Page
Loading...
Need help?
General
