Installation
Video guide: http://bit.ly/2F7yGcB
Mounting the rear camera
Mount the rear camera as shown below, using rear camera extension
cable, connect rear camera to the main unit.
Red Wire: This wire provides 12 Volt (V) power to your back-up camera.
This can be connected to any 12V power source on your vehicle.
However, it’s recommend to connect to your reverse lights so the
camera only turns on when the vehicle is in reverse. Note: If your
vehicle is equipped with trailer wiring, it’s recommended to connect to
the 12V reverse light wire contained within your trailer wiring harness.
Please refer to the wiring diagram(s) for your specific vehicle and/or
trailer harness to determine the correct color 12V wire for the reverse
lights.
To Next Page
Loading...
