PRV Audio DSP 2.8X - Output Gain and Master Volume; Saving, Loading, and Resetting Settings; Copying Channel Settings

SAVE SLOT1
8Channels_PRV->
To load previously saved settings use the “LOAD” function. This function also allows the factory presents to be loaded via the “DEFAULT”
memory.
If you want to restore all of the DSP 2.8X’s factory settings, simultaneously hold down the “OUTPUT SELECT” shortcut keys for outputs 1, 2
and 3 while turning on the device.
This procedure will erase all internal settings and saves.
LOAD
Default
FACTORY RESET
NO [YES]
OUT1: ON
GRAPH EQ: ON
MUTE ALL (ENTER)
GRAPH EQ: ON
ON ALL [ENTER]
GRAPH EQ: ON
The outputs can be switched individually on and off quickly by holding down the OUTPUT SELECT that corresponds to the output. The LED
color indicates the status of the output.
- BLUE: Output ON.
- RED: Output OFF (MUTE).
In the “MUTE” screen, you can still turn off and on all the output channels simultaneously using the “MAIN CONTROL” go to the output field
and select “ALL-ENTER” or “ALL-ENTER ON”. Then fast touch on “MAIN CONTROL”. You can also turn the input graphic equalizer on or off.
• ON/OFF OUTPUT (MUTE)
LIMITER
THRES.: -9.5 dB
LIMITER
ATTACK: 0.1 ms
LIMITER
RELEASE: 500 ms
This menu allows you to adjust the gains of the individual outputs within a range of -45 to +15 dB, as well as to increase the master
volume of the DSP 2.8X from 0 to 100%.
• OUTPUT GAIN
MASTER LVL: 82%
OUT1 GAIN: +3dB
The DSP 2.8X has four memory slots available for saving personalized settings, accessed via the “SAVE” function. Saved settings can be
named with titles up to 15-characters long. Besides the memory space available to the user, there is autosave, where all parameters and
settings are saved in a separate working memory. Or rather, if there is a drop in power or the product is turned off during configuration, the
settings will not be lost. This function cannot be disabled.
• SAVE / LOAD / FACTORY RESET
This function allows you to copy all audio settings from one output channel to another.
The copied functions are: parametric output equalizer, routing, crossover, alignment, phase inversion, limiter, gain and mute.
1. Select an “SOURCE” output channel using the “OUTPUT SELECT” hotkeys or by turning the “MAIN CONTROL”, fasten “MAIN CONTROL”;
2. Select a “DESTINATION” output channel using the “OUTPUT SELECT” shortcut keys or by turning the “MAIN CONTROL”, fasten “MAIN CONTROL”;
3. The confirmation message will appear. If confirmed, as output channels from “ORIGIN” to the “DESTINATION” output channel, overwriting as the
“DESTINATION” output channel.
• COPY CHANNEL
COPY CHANNEL
Source:OUT1
COPY CHANNEL
Destination:OUT2
COPY CHANNEL
NO [YES]