PS Engineering PA50 - Table of Contents

To Next Page

To Previous Page

Table of Contents

SECTION I - GENERAL INFORMATION...................................................................... 1-1

1.1 INTRODUCTION........................................................................................................... 1-1

1.2 SCOPE ............................................................................................................................. 1-1

1.3 EQUIPMENT DESCRIPTION ..................................................................................... 1-1

1.4 APPROVAL BASIS -...................................................................................................... 1-1

1.5 SPECIFICATIONS......................................................................................................... 1-2

1.6 EQUIPMENT SUPPLIED ............................................................................................. 1-2

1.7 EQUIPMENT REQUIRED BUT NOT SUPPLIED .................................................... 1-3

1.8 LICENSE REQUIREMENTS ....................................................................................... 1-3

SECTION II - INSTALLATION........................................................................................ 2-1

2.1 GENERAL INFORMATION ........................................................................................ 2-1

2.1.1 SCOPE ...........................................................................................................................2-1

2.1.2 CERTIFICATION REQUIREMENTS.................................................................................... 2-1

2.2 UNPACKING AND PRELIMINARY INSPECTION................................................................ 2-1

2.3 EQUIPMENT INSTALLATION PROCEDURES .................................................................... 2-1

2.3.1 COOLING REQUIREMENTS.............................................................................................. 2-1

2.3.2 MOUNTING REQUIREMENTS........................................................................................... 2-1

2.3.3 CONNECTOR ASSEMBLY ................................................................................................ 2-2

2.4 CABLE HARNESS WIRING ............................................................................................... 2-2

2.4.1 NOISE ............................................................................................................................. 2-2

2.4.2 POWER (PIN 25).............................................................................................................. 2-2

2.4.3 UNSWITCHED INPUTS (PINS 3, 4, 15, AND 16) ............................................................... 2-2

2.4.4 OUTPUT WIRING ............................................................................................................. 2-2

2.5 ADJUSTMENTS.................................................................................................................. 2-2

2.6 POST INSTALLATION CHECKOUT ................................................................................... 2-3

2.6.1 OPERATIONAL CHECKOUT ............................................................................................. 2-3

2.7 FINAL INSPECTION........................................................................................................... 2-3

SECTION III OPERATION .............................................................................................. 3-1

SECTION IV- WARRANTY AND SERVICE.................................................................. 4-1

4.1 WARRANTY ...................................................................................................................... 4-1

4.2 FACTORY SERVICE .......................................................................................................... 4-1

APPENDIX B – INSTALLATION DRAWING

........................................................... B

APPENDIX C CONNECTOR INTERCONNECT ......................................................C

Record of revisions:

Revision Date Reason

New Release October 2006 New Release