Page 18 202-890-0913 PMA8000G Pilot Guide R3
Streamer on/off
The PS Streamer defaults to “off” when the audio
panel is turned on each time. You will need to acti-
vate the PS Streamer for each flight is desired, but
pairing will not be necessary. The module will recon-
nect when activated.
Press and hold the AUX and SPR buttons (1) at the same time to ac-
tivate the PS Streamer when it has been turned off. If paired device is
present the Bluetooth indicator will light.
Volume
Momentarily press the following buttons at the same time until you
hear a chime. The volume increases or decreases in 8 steps. Pressing
NAV 1 & AUX (3) buttons at the same time will decrease all the au-
dio being sent to the Bluetooth device. Pressing the NAV 2 & AUX
(4) at the same time will increase the volume of all the audio sent to
the Bluetooth device. An audio numerical announcement of the vol-
ume level setting is provided.
Source Selection
The output can contain either the audio heard by the pilot (radio, in-
tercom, music, etc.) or communications radio audio.
Press and hold the MUSIC & SPR button until you hear “COM Au-
dio” in the headset, to select communica-
tion radio only.
Press and hold the MUSIC & SPR button
again until you hear “Headset Audio” in
the headset, to select all audio heard by the
crew.
These audio messages are only heard by the crew.
VOLUME DOWN
VOLUME UP