ASSEMBLY
1. Remove the spreader and
components from carton and
place hopper up-side down on
a padded surface as shown.
Insert ends of leg into handle
brace as shown and align
holes. Attach brace and leg to
frame using (4) 1/4-20 x 2” hex
bolts, lockwashers, and nuts.
3. Turn spreader upright on
wheels. Insert screen into
hopper sliding it under the
screen clips. Attach the upper
handle assembly to handle
brace with the handle lever
brackets facing as shown.
Secure with (4) 1/4-20 x 1 1/2”
hex bolts, lockwashers and
nuts.
2. Slide drive and free wheel onto
axle as shown with the longer
portion of wheel hub facing the
frame. Secure free wheel with (1)
5/32 dia. x 1 1/4” cotter pin. Attach
drive wheel to axle with (1) 3/16 dia.
x 2” cotter pin.
5/32 Dia. x
1 1/4” Cotter
Pin
3/16 Dia. x
2” Cotter Pin
NOTE POSITION OF
LEVER BRACKETS
Drive Wheel
Free Wheel
Handle
Brace
Leg
1/4-20 X 2”
Hex Bolt
1/4-20 NUT
Upper Handle
Assembly
Screen
Screen Clip
1/4-20 X 1 1/2”
Hex Bolt
1/4-20 NUT
&
LOCKWASHER
LOCKWASHER
To Next Page
Loading...