Need help?Do you have a question about the PSC QuickScan QS6500 and is the answer not in the manual?
Step-by-step instructions for establishing a wireless connection between the imager and base station.
Details the methods available to break the wireless link between the imager and base station.
Covers modes like 'Good read off', 'Momentary', 'Alternate', 'Timeout off', and 'Stand Mode'.
Settings for minimum and maximum code lengths applicable across symbologies.
Allows choosing the desired interface type for connecting the imager.
Configuration options for the RS-232 serial communication interface.
Settings for Keyboard Wedge and USB Keyboard interfaces, including layout.
Configuration options for Wand Emulation interface, including symbologies and format.
Allows adding up to 22 ASCII characters as a prefix or suffix to barcode data.
Enables automatic synchronization of imager and base station configuration.
Allows linking the imager to any Bluetooth enabled device.
General| Type | Handheld |
|---|---|
| Scan Engine | Laser |
| Light Source | 650 nm visible laser diode |
| Connectivity | USB, RS-232, Keyboard Wedge |
| Scan Rate | 100 scans/sec |
| Decode Capability | 1D |
| Reading Distance | 0.5 to 50 cm |
| Resolution | 0.1 mm |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 5% to 95% (non-condensing) |
| Drop Specification | 1.5 m |
To Next Page
