- 4 -
Operating Instructions
1. Plug the power cord into the socket and turn on the power，the machine works.
2.Place the machine on the object to be cleaned (such as the bed), turn on the switch, make
sure that the two small wheels (safety switch) at the bottom of the machine are pressed into
the machine body, then the UV lamp starts to work, push and pull the machine back and
forth slowly for cleaning. ( the cleaning speed be less than 20 seconds per meter and three
times of back and forth cleaning)
3.When the power switch is turned on, the two beaters at the front end also start to work,
which can shake out the mites and dust hidden in the depth of the quilts and remove them.
The cleaning effect is better.
4.When the machine works,the position of the air outlet shall not be covered by any object,
and there shall be no object blocking around the air outlet, otherwise the machine maybe
overheats and cause malfunction; After using the machine, do not block the air outlet, so that
the heat inside the machine will be released as soon as possible, so as to ensure the service
life of the machine.
5.After using the machine, press the power switch button to stop the machine, and then pull
the power cord plug out of the socket.
To Next Page
Loading...