PT M545 User Manual

SPECIFICATIONS:
Nozzle diameter: ......................................5 mm
Hopper capacity: ........................... 17.2 fl. oz. (510 ml)
Maximum air pressure (P.S.I.) ............................... 90
Air consumption (CFM) .................................... 6
Air inlet (NPT) ........................................ 1/4 in.
Weight: .......................................14 oz. (0.4 kg)
Specifications are subject to change without notice.
OWNER'S MANUAL

WARNING: READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO SO MAY
RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND WILL
VOID WARRANTY.
Some dust created by sand blasting contains chemicals known to the State of California to cause cancer, birth defects
or other reproductive harm. An example of this type of chemical is lead from lead based paints, Crystalline Silica from
bricks and cement or other masonry, Arsenic and Chromium from chemically treated lumber. Your risk from these
exposures varies, depending on how often you do this type of work. To reduce your exposure: work in a well ven-
tilated area and work with approved safety equipment, such as dusk masks that are specially designed to lter out
microscopic particles.
AIR POWERED
ABRASIVE SPOT BLASTER
Item Number M545

PT M545 Specifications

General

Brand	PT
Model	M545
Category	Tools
Language	English

Summary

SPECIFICATIONS

IMPORTANT SAFETY INFORMATION

General Safety Precautions

Safety guidelines for work area, children, storage, PPE, and operational procedures like footing and balance.

Specific Tool Warnings

Critical warnings about oiling the tool, air pressure, dust hazards, and operating under the influence of substances.

Operational Safety Procedures

Guidelines for connecting air supply, using accessories, maintenance, repairs, and avoiding misuse or alterations.

Manual Limitations & Operator Responsibility

Understanding manual limits, emphasizing common sense, caution, and reading other tool manuals for comprehensive safety.

AIR SUPPLY SETUP

Regulator, Shutoff Valve, and Hose Connection

Instructions for installing an air regulator, shutoff valve, and connecting the air hose to the tool for safe operation.

TOOL SETUP

Hopper Filling and Media Preparation

Guidance on filling the hopper with abrasive media, emphasizing dry and appropriate grain size for optimal performance.

WORK AREA SETUP

Preparing the Work Environment

Steps for designating a clean, well-lit area, routing hoses safely, and isolating the workpiece for safe blasting.

TYPES OF ABRASIVES

OPERATING INSTRUCTIONS

Connecting and Blasting Procedure

Steps for connecting the air supply, holding the gun, aiming, and operating the trigger to perform abrasive blasting.

OPERATING INSTRUCTIONS CONT.

Performance Tuning and Post-Use

Guidance on adjusting distance, refilling media, and procedures after finishing operation, including disposal.

MAINTENANCE

Routine Care and Storage

Instructions for inspecting the tool before and after use, cleaning, and storing it safely for longevity.

TROUBLESHOOTING

EXPANDED PARTS LIST

LIMITED WARRANTY