OPERATION - JACK STANDS
Read these safety warnings before operation.
WARNING!
Failure to heed these warnings may result in loss of load,
damage to jack, and/or jack failure resulting in personal injury
or property damage.
WARNING!
Do not overload jack stands beyond rated capacity.
Overloading can cause damage to or failure of the jack stands.
POSITION LOAD ON CENTER OF SADDLE ONLY. ALWAYS USE
STANDS IN PAIRS ON HARD, LEVEL SURFACE CAPABLE OF
SUSTAINING THE LOAD. USE OF STANDS ON OTHER THAN
HARD LEVEL SURFACES CAN RESULT IN STAND INSTABILITY
AND POSSIBLE LOSS OF LOAD.
Be sure all personnel are clear of load before lowering load.
Ensure that no personnel pass underneath load until load is
securely supported by jack stands.
SPECIFICATIONS - JACK STANDS
Capacity: .................... 4,000 lbs.
Low Height: ................ 10-3/8 in.
Max. Height: ............... 16-3/8 in.
Lift Range: ........................... 6 in.
Specifications are subject to
change without notice
IMPORTANT SAFETY INFORMATION
MAINTENANCE & INSPECTION - JACK STANDS
1. Refer to your vehicle owner's manual for proper jacking procedures.
Lift only on areas of the vehicle as specified by vehicle manufacturer.
2. Position stands under vehicle at points specified by vehicle manufacturer
as proper load support points.
3. To adjust stands: Hold control lever up while lifting saddle shaft to desired
height. Push control lever down to lock pawl into teeth located in center
column. MAKE SURE PAWL IS FULLY ENGAGED INTO TEETH.
4. Carefully lower load onto stands.
Saddle
Pawl
Center
Column
Control
Lever
1. Visual inspection shall be made before each use of the stands, checking
for cracks, cracked welds and missing and/or damaged parts. Any stand
that appears to be damaged in any way shall be removed from service
immediately.
2. BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED WITH THE
MISUSE OF EQUIPMENT OF THIS TYPE, NO MODIFICATIONS SHALL
BE MADE TO THE PRODUCT.
To Previous Page
Loading...