What to do if the PTM HL weight fluctuates, or it is not stable while working only?
If your PTM Accessories weight is unstable during operation, it might be due to damaged or broken cables. The solution is to replace the damaged cables.
How to fix incorrect weight shown by PTM HL Accessories?
If the weight displayed by your PTM Accessories is incorrect, perform a new calibration of the system as outlined in the specific documentation.
What to do if PTM HL scale does not switch on or shows 'Low Bat' message?
If your PTM Accessories scale fails to power on or displays a 'Low Bat' message, verify that the power supply meets the product's technical specifications. Check the power supply cable for any breaks or damage, and inspect the power plug and battery clamps for oxidation. Replace any faulty components as needed.
Why does the PTM HL weight fluctuate, drift, or show ERROR?
If the weight reading on your PTM Accessories fluctuates, drifts, or shows an error, the connected load cell might not be functioning correctly. In this case, it's best to contact service for assistance.
How to stabilize the weight on PTM HL Accessories?
If the visualized weight value on your PTM Accessories keeps fluctuating, it indicates that the scale was out of range. Pressing the T/CLEAR key should resolve this issue through the scale software.
What to do if the PTM HL weighing scale switches off when the alarm rings?
If your PTM Accessories weighing scale turns off when the alarm activates, the alarm itself may be faulty. Replace the alarm.
What to do if the PTM HL tank lays on the frame?
To resolve the issue where the PTM Accessories tank is resting on the frame, ensure the tank does not touch the frame at any point.
Lists functions specific to the HL Series 20 weighing indicator.
Lists functions specific to the HL Series 25 weighing indicator.
Lists functions for HL Series 30 and 30 TOPCUT models.
Lists functions for HL Series 50 and 50 TOPCUT models.
Configure advanced component parameters, consumption, and names.
Accesses the menu for programming recipes, including load/unload sequences.
Guide on entering and navigating the user codes menu for parameter settings.
Addresses issues where the visualized weight fluctuates up and down.
Addresses issues where the visualized weight increases and decreases erratically.
Diagnoses why the scale switches off when the alarm activates.
Provides steps to troubleshoot incorrect weight readings.
Guides on troubleshooting power-on issues and low battery messages.
General| Brand | PTM |
|---|---|
| Model | HL Series |
| Category | Accessories |
| Language | English |
To Next Page
