PUDU ROBOTICSPUDU ROBOTICS
15
It is necessary to add fences or other barriers at the edge of a staircase, entrance to a downslope, or
other places where the robot is at risk of falling.
Things that are black (for example, skirting line), polished (for example, wall), or transparent (for
example, French window) at a height of 20 to 26cm or below may interfere with the radar and cause
abnormal moving of the robot. Such sites should be modied (e.g., posting stickers).
8°
8°
20~26cm
1.2 Instructions on power supply and power usage
When the battery drops to 20%, the robot should be charged timely. Running at a low battery for
a long time may impair battery life.
If not used for a long time, the robot should be shut down to protect the battery.
Always use the original rechargeable batteries and chargers. Do not charge your robot using
non-original chargers.
Charge the robot according to the power voltage indicated on the charger nameplate.
If the robot battery is at fault, please contact the manufacturers for replacement, do not have
it operated by a non-professional.
Do not charge the robot near ammable and explosive objects.
The maximum possible slope is 8° for the robot. To prevent spilling, the suggested slope should be
less than 5º, and the limit of 7.5° should not be exceeded. To prevent sliding, the robot should not be
paused when moving uphill. To prevent falling, the slope should be at least 80cm wide, and the roll
angle should not exceed 8° .
To Next Page
Loading...