TEMPERATURE SETTINGS:
1. Clean carb cap and glass by soaking in
isopropyl alcohol. Rinse clean with water after.
2. Clean gold threads and connector in the base
with a cotton swab.
3. To clean the atomizer, unscrew from base, and drop
the fully assembled atomizer into iso for 30 minutes.
*Be careful removing the atomizer after it was just used,
it will be hot to the touch. Allow time to cool.
WARNING: After cleaning, allow all parts to
thoroughly dry before use. (iso is flammable)
*Do not get the base wet - it’s electric - it will break.
*Do NOT attempt to disassemble the atomizer before
submerging fully assembled into iso.
CLEANING:
10
Preparation: Remove glass before unscrewing and
re-inserting atomizer (do not overtighten, don’t force it).
To Next Page
Loading...
