Problem solving
The S1300H is designed and manufactured for severe environments and tasks, but the user must note
that the machine must be protected from knocks and blows. Filter, seals, attachments, and connections
are carefully adapted and selected with regard to the operator’s work environment. Therefore, the
operator and service personnel must treat the machine with care in order to work correctly for many
years.
Problem Cause Procedure
Motor does not start No power Connect the machine
Cable defective Change
Switch defective Change
Motor stops immediately Wrong fuse Connect to correct fuse
after starting
Motor runs but there is no Hose not connected Connect hose
suction Hose blocked Clean hose
No plastic bag Fit plastic bag
Motor runs but suction Hole in the hose Change hose
Poor Filter blocked Change filter
Top cover loose Adjust
Sealing defective Change current seal
Dust blows from motor Filter loose or defective Adjust or change
Abnormal noise Order service
KEEP THESE INSTRUCTIONS!
To Next Page
Loading...
Need help?
General