Introduction
Dear Customer,
Thank you for choosing Pullman-Ermator as your supplier.
We hope that the Pullman-Ermator S1300 dust extractor will be to your satisfaction and meet your
expectations.
Pullman-Ermator has been manufacturing professional dust extractors since 1966 and has over the
years acquired a genuine technical knowledge in this area. We are continuously striving to improve
our products in our product segment and will continue to supply the market with new equipment.
Please feel free to browse information about our product programme on our web site
www.Pullman-Ermator.se.
Notice!
These instructions are only for dust extractor type Pullman-Ermator S1300.
The Pullman-Ermator S1300 dust extractor can only be used with dry, non-explosive material.
The Pullman-Ermator S1300 dust extractor has been designed to clean construction areas and
be connected to small electrical machines such as drills etc.
Pullman-Ermator will not be held responsible if the dust extractor is used for other applications
or been used in ways other than those outlined in this instruction manual.
Please pay particular attention to the safety regulations.
Read the complete instruction manual before using the Pullman-Ermator S1300.
All spare parts used with the Pullman-Ermator S1300 must be those specified by Pullman-
Ermator.
To Next Page
Loading...