Pulmonetic Systems LTV Series

To Next Page

LTV

Series Ventilator

(LTV

1000, 950, and 900)

Operator’s Manual

P/N 10664, Rev. Y

Main Page

Default Chapter7
- Table of Contents7
Chapter 1 - Introduction13
- Operator's Safety Information14
- Warnings15
- Cautions24
- Symbols30
Chapter 2 - Ventilator Overview31
- Intended Use31
- Power/Supplies Required32
- Information/Assistance33
Chapter 3 - Breath Types35
- Breath Types35
Chapter 4 - Ventilation Modes41
- Control Mode41
- Assist/Control Mode41
- SIMV Mode42
- CPAP Mode43
- Apnea Backup44
- Nppv45
- Volume / Pressure Ventilation46
- Bias Flow46
Chapter 5 - Using the Controls and Indicators47
- Ventilator Controls47
- Setting a Control48
- Variable Controls48
- Buttons49
- Set Value Knob49
- Extended Features49
- Mechanical Controls50
- Bright, DIM and Blank Control Displays51
- Flashing Controls52
- Dashes52
- Control Limiting52
- Control Locking53
- Control Retention53
Chapter 6 - Controls55
- Assist/Control / SIMV/CPAP Modes55
- Breath Rate56
- Control Lock57
- High Pressure Limit58
- Inspiratory / Expiratory Hold59
  - Inspiratory Hold60
  - Expiratory Hold62
- Inspiratory Time64
- Low Minute Volume65
- Low Pressure66
- Low Pressure O67
- Manual Breath71
- O2 % (O2 Flush) (LTV® 1000 Only)72
- On / Standby74
- PEEP Valve75
- Pressure Control (LTV ® 1000 & 950 Only)77
- Pressure Support79
- Select81
- Sensitivity82
- Set Value Knob83
- Silence / Reset84
- Tidal Volume85
- Volume / Pressure Mode (LTV® 1000 & 950 Only)86
Chapter 7 - Displays and Indicators87
- Airway Pressure87
- Display Window87
- Indicators87
- Battery Level88
- Charge Status90
- External Power91
- Nppv92
- Patient Effort92
- Vent Inop92
Chapter 8 - Monitored Data94
- Automatic or Manual Data Display Scrolling94
- PIP XXX Cmh2O95
- MAP XX Cmh2O95
- PEEP XX Cmh2O95
- F XXX Bpm95
- Vte XXX Ml96
- VE XX.X L96
- I:E XX:XX96
- I:ecalc XX:XX96
- Vcalc XXX Lpm96
Chapter 9 - Ventilator Alarms97
- APNEA, APNEA XX Bpm98
- Bat Empty99
- Bat Low101
- Defaults103
- Defaults Set105
- Disc/Sense106
- HIGH F107
- High Opres108
- High Peep109
- High PRES110
- Hw Fault112
- Inop113
- Low Min Vol114
- LOW OPRES (LTV® 1000 Only)115
- Low Pres116
- NO CAL DATA, no CAL Monitor Display117
- Power Lost118
- Power Low119
- Remove Ptnt120
- Reset / Reset 1121
- Xdcr Fault122
- Alarm Status Messages123
  - Peep off123
  - Hi Peep off123
  - HIGH F off124
  - Lmv Lpps off124
  - Lmv off124
  - Locked125
  - Lpps off125
  - WARMUP XX126
Chapter 10 - Extended Features127
- Navigating the Extended Features Menus128
- Alarm Operations129
- Alarm Volume129
- Apnea Interval130
- High Pressure Alarm Delay130
- Low Peak Pressure Alarm130
- High F131
- High PEEP131
- Patient Assist132
- Exit132
- Vent Operations133
- Transducer Autozero149
- Real Time Transducers153
Chapter 11 - Ventilator Checkout Tests157
- Alarm Test157
- Display Test158
- Control Test160
- Leak Test162
- Vent Inop Alarm Test164
- Exit166
Chapter 12 - Operating Procedure167
- To Turn the Ventilator on167
- Before Connecting the Ventilator to a Patient168
- Procedure for Control Mode Set up170
- Procedure for Assist / Control Mode Set up171
- Procedure for SIMV Mode Set up172
- Procedure for CPAP Mode Set up173
- Procedure for NPPV Mode Set up174
- To Turn the Ventilator off175
- LTV® Ventilator Settings Checklist176
Chapter 13 - Cleaning, Disinfecting and Sterilizing177
- Cleaning the Ventilator177
- Cleaning or Replacing the Fan Filter178
- Cleaning or Replacing the Inlet Filter179
- Cleaning or Replacing the O2 Inlet Filter180
- Cleaning the Exhalation Valve and Reusable Patient Circuit182
Chapter 14 - Power and Battery Operation189
- Using the AC Adapter190
- Using an External Battery191
- Using the Automobile Cigarette Lighter Adapter194
  - Replacing the Automobile Adapter Fuse198
- The Universal Power Supply (UPS)198
- The Transport Battery System (TBS)198
- The Sprintpack Li-Ion Power System199
- Caring for the Internal Battery200
  - Battery Disposal200
Chapter 15 - Troubleshooting201
- Displays and Buttons202
- Ventilator Performance205
- Power and Battery Operation214
- Alarms216
- Checkout Test Failures223
- Test Lung Operations225
  - Equipment Classification232
  - Regulatory Requirements234
Appendix A - Ventilator Specifications235
Appendix B - Set up / Maintenance235
- Recommended Maintenance Schedule235
- Service Assistance236
Appendix C - Installation and Checkout237
- Installation and Setup237
Appendix D - Principles of Operation259
- Overview259
Appendix E - Event Trace261
- Event Codes263
  - Event Codes by Code263
  - Event Codes by Event Name266
Appendix F - Glossary269
Appendix G - Index273

Other manuals for Pulmonetic Systems LTV Series

Service Manual318 pages

Need help?

Do you have a question about the Pulmonetic Systems LTV Series and is the answer not in the manual?

Pulmonetic Systems LTV Series Specifications

General

Model	LTV Series
Tidal Volume Range	50-2000 mL
FiO2	21-100%
PEEP Range	0-20 cmH2O
Manufacturer	Pulmonetic Systems
Type	Ventilator
Modes of Ventilation	CPAP, Pressure Support
Power Source	AC Power, Internal Battery

Related product manuals

Pulmonetic Systems LTV 950

277 pages

Pulmonetic Systems LTV 1000

277 pages

Pulmonetic Systems LTV Series - User Manual

Table of Contents

Other manuals for Pulmonetic Systems LTV Series

Pulmonetic Systems LTV Series Specifications

Related product manuals