Need help?Do you have a question about the Pulnix TM-7CN and is the answer not in the manual?
General| Camera Type | Monochrome CCD Camera |
|---|---|
| Sensor Type | CCD |
| Resolution | 570 TVL |
| Lens Type | C-mount |
| Lens Mount | C-Mount |
| Shutter Speed | 1/60 to 1/100, 000 sec |
| Video Output | 1.0Vp-p, 75 Ohms |
| Scan System | 2:1 Interlace |
| Synchronization | Internal/External |
| Power Supply | 12 VDC |
| Operating Temperature | -10°C to +50°C |
State-of-the-art 1/2 inch high resolution CCD imager for versatile applications.
Substrate drain-type shutter mechanism allows variable speeds from 1/60 to 1/10,000 sec.
Excellent low light capability, detecting near infrared, requiring minimal illumination.
Photosensor elements form exact rows, ensuring very precise image geometry.
Pinout and function of the 12-pin connector for camera accessories.
Details the SC-745 shutter control unit and recommended power cables.
Guide to connecting the 12V DC power supply and power cables to the camera.
Initial checks and recommendations for setting up PULNIX cameras.
How to connect the BNC video output to monitors, VCRs, or switching devices.
Attaching C-mount lenses, back focusing, and auto-iris lens setup.
Using the SC-745 Shutter Controller for external shutter speed adjustment.
Controlling shutter speeds via D0, D1, D2 inputs or the SC-745 controller.
Explains the substrate drain type shutter mechanism for smear-free images.
Details TTL level internal sync and buffered pixel clock output signals.
Explains the fundamental principles of Charge Coupled Devices (CCDs) and photoelectric conversion.
Describes the vertical and horizontal charge transfer processes within the CCD sensor.
Graph showing the relative sensitivity of the CCD sensor across different wavelengths.
Explains the differences between FIELD and FRAME modes for scanning and integration.
Instructions for connecting and testing the Sync Gen board, including jumper settings.
Steps for connecting and testing the Processor board, including jumper and voltage settings.
Connecting and testing the Imager board, adjusting Vsub voltage for optimal imaging.
Details sync signal types, frequencies, and input impedance for external synchronization.
Procedures for horizontal and vertical phase adjustment for genlock synchronization.
How to select input/output impedance for specific pins on the 12-pin connector.
Details jumper settings for TM-7CN and TM-7EX models, including S-Option.
To Next Page
