Need help?Do you have a question about the Pulnix TMC-7 and is the answer not in the manual?
General| Sensor Type | CCD |
|---|---|
| Lens Mount | C-mount |
| Image Sensor | 1/2 inch CCD |
| Scan System | Interlaced |
| Video Output | 1.0 Vp-p, 75 ohms, composite |
| Power Supply | 12VDC |
| Synchronization | Internal |
Explains the 4-phase drive method and vertical transfer process within the CCD.
Describes the interline-transfer architecture of the CCD sensors and charge flow.
Provides essential information on powering the camera, including connector details and power requirements.
Details the pin assignments of the 12-pin connector and available power cables.
Provides a step-by-step guide for performing mechanical back focus adjustment on the camera.
Specifies the required potentiometer settings for matrix and auto-white balance boards.
Details the procedure for setting white balance using specified test equipment.
Explains how to adjust the Y level and setup level using a waveform monitor.
To Next Page
