What to do if my PULOX PO-200A Medical Equipment device can't be turned on?
If your PULOX Medical Equipment device won't turn on, the batteries might be drained. Try changing them. Also, make sure that the batteries are correctly installed. If the problem persists, it may indicate a device malfunction.
Why SpO2 and pulse rate are not displayed normally on my PULOX PO-200A Medical Equipment?
If the SpO2 and Pulse Rate are not displaying correctly on your PULOX Medical Equipment, ensure your finger is properly positioned in the device and try again. If the issue persists, it's possible that your SpO2 level is too low to be detected. If you believe the device is working properly, consider seeking a professional medical diagnosis.
What to do if the display of my PULOX Medical Equipment suddenly turns off?
If the display of your PULOX Medical Equipment suddenly turns off, it may be due to one of two reasons: the device automatically powers off after 5 seconds without a signal, in which case you should turn on the device and insert your finger, or the batteries are almost drained, in which case you should replace them.
How to fix unstable SpO2 and pulse rate readings on PULOX PO-200A?
If the SpO2 and Pulse Rate readings are unstable on your PULOX Medical Equipment, make sure your finger is placed deeply enough inside the device. Also, ensure that the patient remains still, as movement can interfere with the readings. Try to calm the patient down.
Guidelines for safe usage and maintenance checks.
Important cautions regarding device usage and patient safety.
Points requiring user consideration for optimal performance.
Specifies the intended purpose and application of the device.
Categorization of the medical device according to regulations.
Highlights the main characteristics and benefits of the oximeter.
Details where and for whom the device can be used.
Specifies the conditions for storage and operation.
Explains the technical basis for measuring SpO2 and pulse rate.
Important points to observe for accurate measurement.
Conditions or factors affecting measurement accuracy.
Information about the light source and receiver for measurement.
Settings for user-defined alarm limits.
Identification of components on the device's front.
Instructions for battery installation and replacement.
Steps for attaching the device's carrying strap.
Step-by-step guide for taking readings.
How to orient the screen display.
Method to temporarily silence audible alerts.
Navigation and control of the device's menu system.
Procedure for configuring alarm thresholds.
Declaration regarding the device's radio frequency emissions.
Declaration regarding the device's resistance to external interference.
Guidelines for safe distances from RF devices.
General| Measurement Parameters | SpO2, Pulse Rate |
|---|---|
| SpO2 Measurement Range | 70% - 99% |
| Pulse Rate Measurement Range | 30 - 250 bpm |
| Pulse Rate Accuracy | ±2 bpm or ±2% |
| Power Source | 2 x AAA batteries |
| Battery Life | Approximately 30 hours |
| Weight | Approx. 50g (including batteries) |
| Type | Pulse Oximeter |
| SpO2 Accuracy | ±2% (70%-99%) |
| Display Type | OLED |
| Auto Power Off | Yes, after 8 seconds of inactivity |
To Next Page
