Pulsar ACCOLADE 2 LRF XP50 PRO - USB Connection; Wireless Remote Control; Technical Inspection; Technical Maintenance and Storage

USB Connection
•
Connect one end of the USB cable(16)to the Micro-USBport of your device, and the other end to the USB
port of your PC/laptop.
•
Turn the device on with a short press of
thebutton (device that has
been turned off cannot be detected by your
computer).
•
Your device will be detected by the computer
automatically; no drivers need to be installed.
•
Two connection modes will appear on the
display:PowerandMemory Card(external
memory).
•
Select connection mode withUP (2)/DOWN
(5)buttons.
•
Conrm selection with a short press of
thebutton.
Connection modes:
Power
•
In this mode PC/laptop is used as an external power supply. The status bar shows icon . The device
continues operating and all functions are available.
•
The Battery pack installed in the device is not being charged!
•
When USB is disconnected from the device when in thePowermode, the device keeps operating with Battery
Pack, if available, and it has sufcient charge.
Memory Card (external memory)
•
In this mode the device is detected by the computer as a ash card. This mode is designed for work with the
les saved in device’s memory. The device’s functions are not available in this mode; the device turns off
automatically.
•
If video recording was in progress when connection was made, recording stops and video is saved.
•
When USB is disconnected from the device where connection is in theMemory Cardmode, the device remains
on the OFF state. Turn the device on for further operation.
Wireless Remote Control
(Bought separately)
Wireless remote control(RC)duplicates the power on function, digital zoom, rangender control, and menu
navigation.
Controller (18) Button ON (19) Button ZOOM (20) 
Brief press
Enter the quick menu Turn on the device
/ Calibrate the
microbolometer
Activate incremental
zoom
Activate rangender
/ Measure distance
Long press
Enter the main menu Display Off / Turn off
the device
Activate function PiP Activate SCAN mode

Increase parameter,
move upwards
18
19
20
21

rotation
Decrease parameter,
move downwards
Technical Inspection
It is recommended to carry out a technical inspection before each use of the device. Check the following:
•
External view (there should be no cracks on the housing).
•
The state of the objective, eyepiece and rangender lenses (there should be no cracks, spot, dust, deposits etc.).
•
The state of the Battery Pack (should be charged) and electric terminals (there should be no oxidation).
•
Correct functioning of the controls.
Technical Maintenance and Storage
Maintenance should be carried out no less frequently than twice a year, and should consist of the following
measures:
•
Wipe external plastic and metal surfaces clean of dust and dirt with a soft cloth moistened with a synthetic
cleaning agent.
•
Clean the electric terminals of the Battery Pack and device’s battery slot using a grease-free organic solvent.
•
Check the objective and eyepieces lenses; rangender’s emitter and receiver lenses. If required, remove
dust and sand (preferably by a noncontact method). Clean the external surfaces of the lenses with products
expressly designed for this purpose.
•
Store the device in a carrying case. Remove the Battery Pack for long-term storage.