Pulsar Axion 2 XG35 User Manual

select the desired calibration mode: Manual (M), Semi-Automatic
(SA) or Automatic (A).
6.
Calibrate the image by briefly pressing the ON/OFF (6)button.If the SA
or A calibration mode has been selected the microbolometer is closed
with an internal shutter automatically. However, if the M calibration
mode has been selected you must close the lens cover before
calibrating manually.
7.
Select the required amplification level (“Normal” , “High”
, “Ultra” ) by briefly pressing the UP (5) button.
8.
Enter the main menu with a long press of the MENU (4) button and
select the desired colour mode (for more details see the Colour Modes
section).
9.
Activate the quick menu by briefly pressing the MENU (4) button to
adjust the brightness, contrast and smooth digital zoom (for more
details see the Quick Menusection).
10.
After use, turn the device off by a long press of the ON/OFF (6)
Warning!Never point the lens at intensive energy sources such as laser
radiation emitting devices or the sun. It can damage electronic components
in the device. The warranty does not cover damage arising from failure to
comply with operating instructions.

Pulsar Axion 2 XG35 Specifications

General

Thermal Sensitivity	<40 mK
Frame Rate	50 Hz
Objective Lens	F35/1.0
Sensor Type	Uncooled Microbolometer
Display Type	AMOLED
Built-in Memory	16 GB
Wi-Fi Channel	2.4 GHz
Protection Degree	IPX7
Operating Temperature Range	-25°C to +50°C
Power Supply	3.0 - 4.2 V
Battery Capacity	4900 mAh
Magnification	2x - 8x
Detection Range	1750 meters
Display Resolution	1024x768 pixels
Video / Photo Resolution	1024x768
Video / Photo Format	MP4 / JPG
Battery Type	Li-Ion
Sensor Resolution	384x288 pixels