Pulsar Axion 2 XG35 User Manual


1.
Connect one end of the USB cable to the USB Type-C port (9) of your
device and the other end to the USB port of your PC / laptop.
2.
Turn the device on with a short press of the ON/OFF(6) button (a
device that has been turned off cannot be detected by your computer).
3.
Your device will be detected by the computer automatically; no drivers
need to be installed.
4.
Two connection modes will appear on the display: Power and Memory
Card(external storage device).
5.
Select the connection mode with the UP (5)/DOWN (3)buttons.
6.
Confirm the selection with a short press of the MENU (4) button.
Power
In this mode, a PC/laptop is used as an external power supply. The
status bar shows the icon . The device continues operating and all
functions are available.
Battery recharge feasibility depends on your computer's USB port.
When the USB is disconnected from the device when in the Power
mode, the device keeps operating with the Battery Pack if it is available
and sufficiently charged.

Pulsar Axion 2 XG35 Specifications

General

Thermal Sensitivity	<40 mK
Frame Rate	50 Hz
Objective Lens	F35/1.0
Sensor Type	Uncooled Microbolometer
Display Type	AMOLED
Built-in Memory	16 GB
Wi-Fi Channel	2.4 GHz
Protection Degree	IPX7
Operating Temperature Range	-25°C to +50°C
Power Supply	3.0 - 4.2 V
Battery Capacity	4900 mAh
Magnification	2x - 8x
Detection Range	1750 meters
Display Resolution	1024x768 pixels
Video / Photo Resolution	1024x768
Video / Photo Format	MP4 / JPG
Battery Type	Li-Ion
Sensor Resolution	384x288 pixels