English
15
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the
crown is pushed in completely.
Do not operate the crown when the watch is wet or in water. If used in sea water,
rinse the watch in fresh water and dry it completely.
* When taking a shower with the water resistance 5 bar watch, or taking a bath with
the water resistance 10, 15 or 20 bar watch, be sure to observe the following:
• Do not operate the crown when the watch is wet with soapy water or shampoo.
• If the watch is left in warm water, a slight time loss or gain may be caused. This
condition, however, will be corrected when the watch returns to normal
temperature.
NOTE:
Pressure in bar is a test pressure and should not be considered as corresponding
to actual diving depth since swimming movement tends to increase the
pressure at a given depth. Care should also be taken on diving into water.
TEMPERATURES
[for analogue quartz watch
only]
Your watch works with
stable accuracy within a
temperature range of 5° C
and 35° C (41° F and 95° F).
Temperatures over 60° C or 140° F (50°
C or 122° F for some calibres) may cause
battery leakage or shorten the battery life.
Do not leave your watch in very low
temperatures below –10° C or +14° F (-
5° C or +23° F for some calibres) for a
long time since the cold may cause a
slight time loss or gain.
However, the above conditions will be
corrected when the watch returns to
normal temperature.
+60°C
-10°C
To Next Page
Loading...
Need help?
General
