Pulsar NANO - Operating Mode; Predefined Mode

III Operating mode:
The button controls LED A and LED B. You can independently and simultaneously choose the brightness
level for each LED.
Single push activates LED A and double-click (no more than 0.5sec between) activates LED B.
Each LED has 4 brightness levels: 1 – low, 2 – middle, 3 – strong, 4 – strongest.
You change the brightness level for LED A by single pushes of the button with more than 0.5 seconds in-
tervals. The brightness level for LED B is changed by double-clicks with more than 0.5 seconds intervals.
Note! If LED A and LED B work at level 4 simultaneously, this might exhaust the battery faster or cause
overheating of the headlamp and an automatic light output reduction.
If you want to switch o one of the LEDs, you need to rotate all the levels until you reach level 4, the next
will be – switched o.
IV. Predened Mode
You can enter this mode by 4 sequent pushes of the button.
Note! The interval between 2 pushes needs to be 0.5 of a second (approx.) in order to activate the func-
tions.
After this you have 5 combinations that you can rotate by single pushes of the button.
• combo a: LED A=level 3, LED B = 0
• combo b: LED A = level 2, LED B = mode 2
• combo c: LED A & B = level 3
• combo d: LED A = level 1, LED B = level 2
• combo e: LED A = level 4, LED B = level 4
You can exit from the Predened mode by 4 sequent pushes or by switching o the whole lamp.