To Next Page

To Previous Page

IV. Predened Mode

Selecting brightness settings via the programming mode:

When you enter the Program Mode for the rst time, you have initially 5 empty settings that you can easily program according

to your specic needs and preferences and save the settings you have made.

These 5 settings correspond to the 5 red LEDs from the battery bar. (So, the red LEDs from the battery bar indicate the number

of the setting.)

How can I choose or change a setting?

You can change the settings from 1 to 5 by pressing the control buttons separately. Button 2 is for an ascending

change, while Button 1 is for a descending change.

How can I program a selected setting?

You have to press once Button 1 and Button 2 simultaneously. Then (the current setting indicator) the red LEDs from

the battery bar start to blink constantly to indicate that you can now program the setting. You can choose the level of

brightness for each power LED by pressing Button 1 for LED 1 and Button 2 for LED 2.

How can I save the settings I have made for the particular slot?

To save the setting, you have to press once Button 1 and Button 2 simultaneously.

The next time you enter the Program mode, the last used setting will be automatically activated.

In this mode, you can also check the battery level by pressing twice Button 1 and Button 2 simultaneously.

How can I exit the Program Mode?

By pressing BUT 1 and BUT 2 3 times (0.5 second interval) simultaneously or by pressing and holding for 1 second BUT 1 and BUT 2 simul-

taneously.

BUT 1 and BUT 2 simultaneously: 3 pushes (0.5 second interval) - enter Program Mode

BUT 1 / 2 - choosing ascending/descending setting slot

BUT 1 and BUT 2 simultaneously: 1 push - enter the chosen slot and ready to be programmed

BUT 1 / 2 - choosing the brightness level of each of the two powered LEDs

BUT 1 and BUT 2 simultaneously: 1 push - saves the setting

BUT 1 and BUT 2 simultaneously: 3 pushes (0.5 second interval) OR pressing and holding for 1 second - exit the Program Mode

V Switching Off:

You can turn Nano o from any mode by pressing and holding the button

for 4 seconds.

Pulsar NANO User Manual

Questions and Answers: