12
Step 1
Open the cover of the detergent reservoir by twisting it off.
Step 2
Fill the detergent reservoir with any approved liguid detergent.
Close the cover.
2000 PSI Pressure Washer
Step 3
Attach the soap spray nozzle.
Step 4
To apply the detergent to your work area. Turn the pressure washer switch
to the ON position. Pull the trigger to operate the unit. The pressure washer will mix
the detergent with water. Do not allow the detergent to dry on the object that you are
cleaning.
WARNING: NEVER USE PRODUCTS WITH BLEACH OR CHLORINE
OR ANY OTHER CORROSIVE MATERIALS, INCLUDING LIQUIDS
CONTAINING SOLVENTS (I.E. GAS, OILS ETC), TRI-SODIUM
PHOSPHATE PRODUCTS, AMMONIA, OR ACID-BASED CLEANERS.
THESE CHEMICALS WILL HARM THE UNIT AND CAUSE DAMAGE
TO THE SURFACE BEING CLEANED. ALWAYS READ THE LABEL.
To Next Page
Loading...
