18
Stopping Pressure Washer (See Fig 11-12)
•
Press the start button for 1 second to stop the engine.
•
Press the battery switch to "OFF".
•
Turn off water and squeeze the trigger handle to release all water pressure.
FIG 11
Using the Spray Gun (See Fig 13 - 14)
•
Flip the lock tab behind the trigger up or down until it clicks to apply or remove the safety. Pull back on the trigger to
begin oper
ating pressure washer.
•
FIG 13
FIG 14
Pull cord recoils rapidly and pulls arm towards engine faster than you can let go which
could result in injury.
•
Always relieve pressure from spray gun before pulling starter cord, including every failed attempt to start engine.
•
To avoid recoil, pull starter cord slowly until resistance is felt, then pull rapidly.
ENGINE
STATR
STOP
FIG 1
2
LOCK OUT
SLOT
TRIGGER
To Next Page
Loading...
Need help?
General
