Pulsar TELOS - Page 17

 Open the lens cover 1 .
 Press the ON / OFF 9  button briefly to turn on the device .
 Adjust the eyepiece diopter ring 13  until the symbols in the display are sharp .
 Rotate the lens focus ring 3  to focus on the object being observed .
 To change the magnification , turn the digital zoom adjustment ring 4 .
 Enter the main menu with a long press of the MENU 11 button and select the
desired calibration mode : manual  M , semi - automatic  SA  or automatic  A .
 Calibrate the image by briefly pressing the ON / OFF 9  button ( if the SA or M
calibration mode has been selected ). Close the lens cover when calibrating
manually .
 Activate the quick menu by briefly pressing the  MENU 11 button to adjust the
brightness and contrast of the display and select the desired amplification level
( “ Normal ” , “ High ” , “ Ultra ” ( for more details see the Quick
Menu section ).
 Activate the Smoothing Filter in the main menu to improve the image as the
amplification level increases .
 Select one of the colour palettes in the main menu ( for more details see the Colour
Modes section ).
 Upon completion of use turn the device off by a long press of the ON / OFF
9  button .
Observation conditions : time of day , weather , type of observation objects affect the
image quality . Custom settings for brightness , display contrast as well as the function of
adjusting the microbolometer sensitivity amplification level will help to achieve the
desired quality in a particular situation .
Warning !  Never point the lens at intensive energy sources such as laser radiation
emitting devices or the sun . It can damage electronic components in the device . The