Why is there no image when recording video from Pulsar Quantum Lite XQ30V?
If you're not getting an image when recording video signal from the Pulsar Monocular using an external video recorder, there could be two reasons: 1. The video output of the thermal imager is disabled. Activate the video output. 2. There is no connection. Ensure the video cable is securely connected.
How to fix dark image on Pulsar Quantum Lite XQ30V Monocular?
If the image on your Pulsar Monocular appears too dark, it's likely that the brightness or contrast level is set too low. You can adjust these settings by rotating the controller to increase the brightness and contrast until the image is clear.
Why my Pulsar Quantum Lite XQ30V doesn't work? Batteries?
If your Pulsar Monocular is not working, the batteries may be fully exhausted or defective. Install fresh batteries to resolve this issue.
How to fix blurry image with stripes on Pulsar Quantum Lite XQ30V Monocular?
If the image on your Pulsar Monocular is blurry, with vertical stripes and an uneven background, calibration is to be done.
General| Objective Lens Diameter | 30 mm |
|---|---|
| Detection Range | 1300 m |
| Sensor Resolution | 384x288 pixels |
| Digital Zoom | 2x, 4x |
| Refresh Rate | 50 Hz |
| Microbolometer Resolution | 384x288 pixels |
| Pixel Pitch | 17 µm |
| Display Type | OLED |
| Power Supply | Li-ion battery |
| Eye Relief | 15 mm |
| Waterproof | IPX7 |
| Display Resolution | 640x480 pixels |
| Operating Temperature | -20°C to +50°C |
| Battery Type | Li-ion |
Detailed technical specifications including model, microbolometer, resolution, frame rate, pixel size, optical characteristics, and operational parameters.
Lists key features of the Quantum thermal imaging scopes such as detector size, AMOLED display, magnification, color modes, and calibration options.
Details the operational functions of each control button and the controller, explaining short press, long press, and rotation actions.
Guides the user on how to turn on the unit and perform image calibration for optimal performance.
Describes the different calibration modes: Manual, Automatic, and Semiautomatic, and their procedures.
Addresses common issues such as the unit not turning on, image problems, or recording difficulties, offering corrective actions.
To Next Page