Pulsar TELOS - Page 76

Solution – Switch  the device ʼ s Wi - Fi bandwidth to 2.4 GHz .
More information on solving problems with connection to Stream Vision 2 by
following the link .
Wi - Fi signal is missing or interrupted
Possible cause – Smartphone or tablet is out of range of a strong Wi - Fi
signal . There are obstacles between the device and the smartphone or tablet
( e . g ., concrete walls ).
Solution – Relocate smartphone or tablet into the Wi - Fi signal line of sight .
More information on solving problems with connection to Stream Vision 2 by
following the link .
Rangefinder does not measure distance
Possible cause – There is an object in front of the receiver or emitter lens
preventing signal transmission .
Solution – Make sure that : the lenses are not blocked by your hand or
fingers ; the lenses are clean .
Possible cause – The device is not being held steadily when measuring .
Solution – Keep the device steady when measuring .
Possible cause – Distance to the object exceeds 1000 m .
Solution – Pick an object at a distance not longer than 1000 m .
Possible cause – Low reflection ratio ( i . e . leaves of trees ).
Solution – Pick an object with higher reflection ratio ( see point  Additional
Information  in section  Laser Rangefinder ).
Large measurement error
Possible cause – Inclement weather conditions ( rain , mist , snow )
Legal Compliances and Disclaimers